1. Find a location for your control panel.
Choose a centrally located area and plug in your panel.
Make sure there are no wireless devices within 10ft of Control Panel.
Make sure the Control Panel is away from any large metal objects that could cause wireless interference.
Plug-in the power cable to an outlet.
Press & hold the power button for 3 seconds.
2. Connect your WIFI.
Press the grey bar and slide down.
Press “Advanced Settings”.
Enter the default code 1234.
To locate the local wireless networks, press the empty box.
Press the appropriate wireless network in the area.
Enter the password for your network and press “Connect”.
Wait until the listed network shows “Connected”.
3. Perform A Signal Test.
Press the back arrow.
Press “System Tests”.
Press “Dual-Path Test”.
You’ll know when the test is complete when it shows “Tested Successfully”.
4. Prepare to Place Your Sensors.
Place the sensors in the proper locations. The labels on the boxes will assist you.
Sensor Setup Guides Listed Below:
- Door Sensor Setup Guide
- Window Sensor Setup Guide
- Motion Detector Setup Guide
- Glassbreak Detector Setup Guide