Please follow the instructions below to assemble and install your yard sign that came with your order.
Note: You will need a large head Phillips Screwdriver and a rubber mallet or hammer.
1.) Verify that you have all three components. The aluminum stake, a pack of two screws and the Monitoring Yard Sign.
2.) Place the Yard sign on the stake with the smooth side facing towards you. Make sure the red cap is at the bottom. Then place each screw through the holes on the yard sign and tighten down.
3.) Once your screws are flush to the sign, Remove the red cap from the stake and use a rubber mallet or hammer to pound the stake into the ground.