Please follow the instructions below to assemble and install your yard sign that came with your Plug & Protect™ order.
Note: You will need a large head Phillips Screwdriver and a rubber mallet or hammer.
1.) Verify that you have all three components. The aluminum stake, a pack of two screws and the LiveWatch Monitoring Yard Sign.
2.) Place the Yard sign on the stake with the single groove facing the towards you. Place each screw through the hole on the yard sign into the groove and tighten down.
(Make sure that the top hole is as close to the top of the stake as possible. This will allow for the best height off of the ground.)
3.) Your assembled sign should look like this:
4.) Use your rubber mallet or hammer to pound the stake into the ground.