To clear your Z-Wave Light Module information from the Simon XT, or to clear any network information stored in the module, follow the steps below. Even if the light module has never been added to the panel, you can still follow these steps to ensure that the network is clean:
Follow the steps below to remove a Z-Wave Light Module to the Simon XT...
To add the device, double click the button in the middle of the light or appliance module. (If there is no beep at the panel confirming successful enrollment of the device, try pressing the button again.)
Your Simon XT will beep and show, “Device # Removed”.
Note: If you receive the message, “Unable To Enter Delete Mode” exit out of the Z-wave Delete Mode and wait about 30-60 seconds before re-entering the Z-wave Delete Mode, or reboot the system if you are still unable to enter delete mode after several minutes.