The information below will describe how to properly label a sensor in your Lynx Touch:
1. Serial Number:
Enroll via RF Learning: To enroll the device using RF Learning mode three transmissions
(open/close) of the device will be required. The initial transmission activates the RF Learning
mode and the system will emit a single beep. A second transmission enrolls the serial number
and the system beeps two times and displays “Activate Sensor Again To Confirm”. A third
transmission will confirm the serial number. The system beeps two times and returns to the
Zone programming Screen.
Enter the 7-digit serial number printed on the transmitter using the displayed keypad and
select “Done”. The system beeps one time and returns to the Zone programming Screen.
2. Loop Number:
Used with 5800 Devices. Record transmitter loop number. Entries are 1-4, depending on device being used. Refer to the
transmitter’s instructions or the figure provided for appropriate loop numbers.
3. Zone Description 1:
When programming the Zone Description, after entering the first letter of the description on the
keypad you can use the up and down arrows to scroll through the available pre-programmed zone descriptions.
4. Zone Description 2:
This area is similar to "Zone Description 1" but you are adding a secondary label to the sensor.
5. Device Type:
Select “Device Type”. The system displays the following options (dependent upon the Device
Type selection). Find the device that would be appropriate for the sensor.
6. Response Type:
Select “Response Type”. The system displays the specific options, which are dependant
upon the Device Type that was selected for the zone.
7. Alarm Report:
This field is for Alarms. If Response Type “Trouble” is set up and Alarm Report is set to
“No” the system will still report if Report Alarms was enabled in the Reporter
Enable/disable chime mode for specific device being enrolled (applies to Entry/ Exit, Perimeter, and
Interior Response types only). When turned on the system will be when a door or window has been opened.
With the exception of some transmitters/keypads that may be carried off-premises (5804, 5804BD, 5804BDV,
5804E and 5805-6), each transmitter is supervised by a check-in signal that is sent to the receiver at 70–90
minute intervals. If at least one check-in is not received from each supervised transmitter within a 12-hour
period, the "missing" transmitter zone number(s) and "Supervision" will be displayed.