Adding A Motion Detector To The Concord (60-511-01-95 / 60-511-02-95)
This is how to program sensors into your Concord system. Any hardwired sensors should already be installed and wired to the control panel. Wireless sensors do not need to be installed yet, it may be easier to program them first and mount them afterwards.
Start with the panel disarmed. Then hit 8 and the keypad will say
Type in 4 3 2 1 (or your installer code if you changed it) if it is the right code you will see
Punch in 0 0 and it should say
If you do not see this screen you may need to try the previous steps again without any pauses,
Hit # and you will see
Hit B B B B B B B B (the down arrow) to get to
Hit # and it will say
Hit # again and you will see
Hit # again and it will say
Enter in the correct group for the type of sensor you are adding (use 17 for motions), then hit # and it will tell you to
Or it will tell you to trip the next available sensor number, if you already have some sensors programmed in.
For wireless devices tamper the sensor (by removing the cover and/or battery or pressing the test button).
The keypad will beep and go to the next sensor number. To change the next sensor group before you learn in the next sensor hit * , enter the correct group, and then hit # . If the next sensor is going to be the same type as the last one you can simply trip it now without changing the group.
When you are done adding sensors hit * * * to get back to
Hit the A (up arrow) and it will say
Hit # to exit programming.