The following information will show you how to add a sensor(zone) to your Lynx Touch:
Apply "4-1-1-2" or your (Installer Code)
Press "Add New"
Press "Serial Number"
Open and close the door you wish to add into your system 3 times.
(The FIRST time you open the door the system will beep. The SECOND time it will automatically send the serial number to the system. The THIRD time it will save the information and take you to the previous page.)
Here you can add the sensors names and behavior of the sensor.
Once you have finished the labeling of the sensors, press "Save" and your done.
If you want to better understand the programming on this page you can select the following link:
Exiting Program Mode
1. Select the (Reverse Arrow Key) at the top right corner to exit the current screen. The system returns to the previous screen.
2. Select the (Reverse Arrow Key) as required until system displays a Confirmation screen.
3. Select “Yes” to allow the installer to re-enter Programming mode or “No” to prevent re-entry. If “No” is
selected, you can still re-enter Program Mode by powering down the unit (remove AC and battery power)
and entering Program Mode within 30 seconds of powering up.
4. Select the (Reverse Arrow Key) key again to return to the Home Screen.