This article will show you how to install your GE Sensor Repeater. You can watch the video below or read through the instructions...
Remove the screw holding the casing together and then take a flat-blade screwdriver and pry the case off.
Take the large circuit board and insert it inside the casing. Make sure the interior tabs are holding the board in place.
Now take the black antennas and route them through the small holes at the top of casing.
Install the daughter-board by pushing it through the 8 metal prongs on the main board.
Now take the protective plastic antenna covers and slide them through the antenna wires and then connect the cap.
To install the AC Wiring, you’ll need to route the bare wire through an opening at the bottom of the casing.
Connect the AC wires by inserting the wire with lettering into “GND” and insert the 2nd wire into the “+12”.
Reconnect the front casing and install the screw.
Plug in the power. To tell if the repeater is working, the green LED on the front will be Solid and the red LED will be flashing.
You’re done! Mount the repeater in a central area of the home.