Make sure your system is disarmed during this process. Start by selecting “Settings”
Enter your “Installer Code”, in this case I’m going to use the default which is “1111”
Select “Security Sensors”
Select “Auto Learn Sensor”
At this point, you’ll need to tamper your sensor. To do this, press the tab at the bottom of the motion detector and then remove the casing.
Once it's open, the IQ Panel will beep and ask if you want to add the device to your sensor list. Select “OK”
Here you will need to program the proper information for this device.
- Sensor DL ID: Don't touch this option.
- Sensor Type: Select “Motion Detector”
- Sensor Name: Select an appropriate name or create a "Custom Description"
- Chime Type: This allows you to apply a specific sound to your device when it’s used.
- Sensor Group: This is used to change the behavior of the device.
Group 17 (Recommended) - The sensor will only be on during Arm Away (you'll want this normally as you don't want to set the alarm off on yourself while you walk around the house)
Group 20 - This will have a delay, most won't use this but if you want a delay on one you can do that, it's default on 45 seconds
Group 15 - This will make it so the motion detector is on during Arm Stay and Arm Away, use this for places you want monitored all the time, but you shouldn't be in the area unless the panel is disarmed
- Voice Prompts: This allows you turn on or off the vocal chime.
When ready, select “Add New”
You’re done! Make sure to re-apply casing for your device.