During the setup, make sure the camera is within 30ft of your router.
Connect the camera’s AC adapter to the back of the camera and the other end to a nearby.
The camera will start with a solid red for about 30 seconds. Then it will begin flashing red for about a minute to finish booting up.
Once it goes back to a solid red, hold down the WPS button on the back of the camera for 5 seconds. The red led will change to a flashing blue led indicating you are in WPS mode.
Go and press the WPS button on your router for 10 seconds, you will usually see another
light start to blink on the router.
Wait for a minute or two for the camera to stop blinking.
If it succeeds, the led on the camera will flash green for a bit and then turn solid green.
Go to a computer and open your internet browser. Enter the following in the URL bar...
Select "Click here to add a camera to this account".
Enter a name for your camera and select "Install"
Give the camera a few minutes to configure the network settings.
Once you see this page, your camera has successfully connected to your network. To test your camera and view a live feed, select "Live View".
Here you will be able to view a live feed from your camera.
That's it! You have completed your wireless camera setup.